Also ich habe eine SDrive Max ( Uno R3) in einem 3D Druck Atari 1050 Gehäuse. Jetzt möchte ich noch 1 rote Led als Power Led reinbauen. Wo kann ich die auf der Platine anlöten?
Gruß
SDrive Max LED anschließen
Moderatoren: Sleeπ, andymanone
Online
Gtx.,
andY
- andymanone
- Beiträge: 2581
- Registriert: 17.08.2021 12:34
- Wohnort: Berlin - Suburban
- Has thanked: 522 times
- Been thanked: 860 times
- Kontaktdaten:
Re: SDrive Max LED anschließen
Oder siehe Link, unter Punkt 4: -> How to connect Power- and Activity-LED´sHow to connect:
POWER diode: Anode (longer pin) across a resistor of about 1 kΩ to 5V power supply, cathode (shorter pin) to ground (GND).
ACIVITY diode: Anode via a 470-Ω resistor equal to + 5 V and the cathode to the RX output on the Arduino board.
Note:
Do not connect diodes without resistors or they will burn up, choose larger resistors (e.g. 1.5kOhm) if the diodes are too bright.
Gtx.,
andY
Ressortleiter Hardware - Save the past and use the future!© andYManOne / Demozoo / My brandnew, experimental Album "Apocalyptic Symphony"
Online
- andymanone
- Beiträge: 2581
- Registriert: 17.08.2021 12:34
- Wohnort: Berlin - Suburban
- Has thanked: 522 times
- Been thanked: 860 times
- Kontaktdaten:
Re: SDrive Max LED anschließen
Gerne doch .
Gtx.,
andY
Gtx.,
andY
Ressortleiter Hardware - Save the past and use the future!© andYManOne / Demozoo / My brandnew, experimental Album "Apocalyptic Symphony"
Wer ist online?
Mitglieder in diesem Forum: 0 Mitglieder und 1 Gast